|
strona 18:
LiPo Battery Mode with Low Voltage Detection
The VXL-3m ESC is equipped with built-in Low Voltage Detection
for safe use with Lithium Polymer (LiPo) batteries. The Low Voltage
Detection circuitry constantly monitors the battery voltage. When the
battery voltage begins to reach the minimum recommended discharge
voltage threshold for LiPo battery packs, the VXL-3m will limit the
power output to 50% throttle. When the battery voltage attempts to fall
below the minimum threshold, the VXL-3m will shut down all motor
output. The LED on the speed control will slowly blink red, indicating a
low voltage shutdown. The VXL-3m will stay in this mode until a fully
charged battery is connected. The electronic speed control is factory
set with Low Voltage Detection turned off. Be certain to activate Low
Voltage Detection if you install LiPo batteries in your model.
To turn Low Voltage Detection on (LiPo setting):
1. Make sure the LED on the ESC is on and red.
2. Press and hold the EZ-Set button for ten seconds. The LED will
turn off and then light green. Also, a “rising” musical tone will be
emitted from the motor.
3. Low Voltage Detection is now ON.
To turn Low Voltage Detection off (NiMH setting):
1. Make sure the LED on the ESC is on and green.
2. Press and hold the EZ-Set button for ten seconds. The LED will
turn off and then light red. Also, a “falling” musical tone will be
emitted from the motor.
3. Low Voltage Detection is now OFF.
Never use LiPo batteries while Low Voltage Detection is turned off.
_________________
e10 Speed Passion SP1
e10 4wd Xray XB4
|
RC AUTO
e-mail do ADMINA
FAQ
Szukaj 
Użytkownicy
Zaloguj 
Zarejestruj
